Alstom iSTAT M232 - Page 28

M2x2/EN M/F User Manual
Page 26 iSTAT M2x2
The M
2x2 is supplied with the Level 1 password set to AAAA. Level 2 password has not
been set. AAAA passwords offer no level of protection; all measurements and settings can
be modified. The passwords must be changed from AAAA to activate password level
protection.
Alstom Grid
Figure 11-2a
M232
Multimeter
initial power up display
www.alstom.com/grid
When the M2x2 is first connected to the power system, the user is greeted with the message
shown in Figure 11-2a above. This information will be displ
ayed for a few seconds before the
main menu is shown, initially as shown by Figure 11-2b below, but otherwise displays the
last men
u screen used.
The display is divided into 3 parts separated by two horizontal lines; Top, Main and Bottom.
The Top display tells the operator the name of the main display, the bottom display provides
display specific information and the main display shows the functions for that main display
screen.
The bottom display alternates between the device temperature and web site address.
Main Menu
Figure 11-2b
Measurements
Settings
Resets
Info
Installation
Main Menu display
www.alstom.com/grid
Bottom display
When first switched on or during operation, the main menu of the M2x2 can be accessed to
pressing the LEFT key until the menu is displayed, this is shown in Figure 11-2b and gives
the user
5 options; Measurements, Settings, Resets, Info (Information) and Installation.
Navigation is done by pressing the DOWNor UP
keys and then pressing the OK key to
make a selection. The menu cycles round from Installation back to Measurements.