User Manual M2x2/EN M/F
iSTAT M2x2
Page 34
either th
e DOWN or UP keys until the desired setting is shown, then press OK key to
confirm. When the curser is under the decimal point, the decimal point location and
engineering units (V, KV) can be changed. The LEFT key can be pressed to return to the
Connection Mode setting.
VT primary
Figure 12-4
_275.0KV
VT Primary display
OK Select
Figure 12-5 shows the VT Secondary setting structure. An underscore shows the position of
the curser. Move along by using the RIGHT or LEFT key, changes are made by pressing
either the DOWN or UP keys until the desired setting is shown, then press OK key to
confirm. When the curser is under the decimal point, the decimal point location and
engineering units (mV, V) can be changed. The LEFT key can be pressed to return to the
VT Primary setting.
VT secondary
Figure 12-5
_110.0V
VT Secondary display
OK Select
Figure 12-6 shows the CT Primary setting structure. An underscore shows the position of the
curser. Move along by using the RIGHT or LEFT key, changes are made by pressing
either the DOWN or UP keys until the desired setting is shown, then press OK key to
confirm. When the curser is under the decimal point, the decimal point location and
engineering units (A, KA) can be changed. The LEFT key can be pressed to return to the
VT Secondary setting.
CT primary
Figure 12-6
_2800.0A
CT Primary display
OK Select
Figure 12-7 shows the CT Secondary setting structure. An underscore shows the position of
the curser. Move along by using the RIGHT or LEFT key, changes are made by pressing
either the DOWN or UP keys until the desired setting is shown, then press OK key to
confirm. When the curser is under the decimal point, the decimal point location and
engineering units (mA, A) can be changed. The LEFT key can be pressed to return to the
CT Primary setting.
To Next Page
Loading...