Alstom iSTAT M232 - Settings; Setting Navigation; General Navigation

User Manual M2x2/EN M/F
iSTAT M2x2 Page 38
12. SETTINGS
The settings on the M2x2 are completed using the Keypad and Display; on the M232 they
can also be done using the QDSP software over the communications link.
The Installation Wizard described in section 12.1 is designed to take the user through the
minimum functions necessary to install the M2x2. By pressing the OK key the following
functions can be set:
Language;
Connection Mode: VT Primary: VT Secondary: CT Primary: CT Secondary
Device Address: Baud Rate: Parity: Stop Bit
All these functions can be set individually from the settings menu. Each setting is described
in the following sections.
12.1 Setting Navigation
Figure 13-1 illustrates the Settings menu structure. The user can browse through the
available menus using the direction keys, by pressing the DOWNor UP keys and then
pressing the OK key to make a selection. The LEFT key is pressed to return to the Main
Menu.
Resets
Figure 13-1
Menu name
General
Connections
Communication
LCD
Security
Energy
Inputs and Outputs
Resets display
<- Main Menu
Back to main menu
12.2 General Navigation
Figure 13-2 illustrates the General menu structure. The user can browse through the
available menus using the direction keys, by pressing the DOWNor UP keys and then
pressing the OK key to make a selection. The LEFT key is pressed to return to the Settings
Menu.
General
Figure 13-2
Menu name
Language
Temperature Unit
MD Time constant
Average interval
General display
English
Back to settings menu