Alstom MiCOM P50 Agile P15D - Page 62

5 Configuration
P50 Agile P15D
5-26
P15D/EN TM/B
Earth Fault
Enabled
This window shows the Earth Fault setting done previously.
Press the Plus / Up arrow key (+ /) to move to the next option. ***
Thermal Overload
Enabled
This window shows the Thermal Overload setting done previously.
Press the Plus / Up arrow key (+ /) to move to the next option. ***
Cold Load Pickup
Enabled
This window shows the Cold Load Pickup setting done previously.
Press the Plus / Up arrow key (+ /) to move to the next option. ***
Measure’t Setup
ABC
This window shows the Measure’t Setup setting done previously.
Press the Plus / Up arrow key (+ /) to move to the next option. ***
UnderCurr Prot
Enabled
This window shows the Under Current Protection setting done
previously.
Press the Plus / Up arrow key (+ /) to move to the next option. ***
Setting Value
Secondary
This window shows the Setting Value setting done previously.
Press the Plus / Up arrow key (+ /) to move to the next option. ***
Restore Defaults
No Operation
This window is the first window of Configuration settings.
Press the Left arrow key () or Right arrow key () to return to the
Main Menu.
CONFIGURATION
Note:
*** By using the Left arrow key (  ) or Right arrow key (  ) the relay will return to Main Menu.