Firmware and Service Manual P54x/EN VH/La4
Version History
MiCOM P543, P544, P545 & P546
(
VH) 16-9
H
Relay type: P54x …
Software
Version
Major Minor
Hardware
Suffix
Original
Date of Issue
Description of Changes
S1
Compatibility
Technical
Documentation
A B Feb 2001
Internal loopback setting added (not full functional)
PSL references added
Reset LEDs DDB name change
Text for cells 0F20 - 0F2F changed
Problem whereby MiCOM S1 could only set group 1 line
length corrected
Control inputs added
Restore defaults now restores DNP3.0 cells correctly
Prevent non DNP3.0 builds generating fatal error when S1
request DNP3.0 upload
MODBUS enabling/disabling of IRIG-B now works
Courier/MODBUS event bit functionality corrected
DNP3.0 & MODBUS address are compatible but there are
several new ones
Software is not compatible with previous software (signaling
message)
No official
release to
support this
version. Will
need V2 to
extract PSL files
-
10
Cont.
B B Apr 2001
Internal release for validation only - runs on phase 1 hardware with
a modified co-processor board to accept a 1pps input
Fixed a reset indications problem in CS103 build
Fixed a problem with P544 display of phase C current phase
angle
Setting relay address via rear port corrupted other setting
ranges
As per 10A -
To Next Page
Loading...
