Chapter 4 – Configuration
13 STEADY-STATE
RPV311 allows user to register average series, harmonics, and flicker in the steady-state recorder.
13.1 AVERAGE SERIES
In this section, shown in Figure 36, it is possible to configure the equipment's average series recorder.
The average series the following voltage and current circuits quantities: magnitude or effective value, neutral
magnitude or effective value, frequency, unbalance and total harmonic distortion.
Figure 36: Steady-state recorder – average series configuration section
A The PERIOD scroll box allows user to select the recording average series every 1 or 10 minutes.
13.2 HARMONICS
In this section, shown in Figure 37, it is possible to configure the equipment's harmonics recorder.
To Next Page
Loading...