A Shows the identification and the version of the RPV Tools.
B List of equipment configurations stored locally:
Configuration name defined by the user
Shows location of the equipment.
The location of the equipment is defined in the RPV
configuration. This information is read of the EQUIPMENT >
CONFIGURATION FILE
Shows the identification of the equipment.
The identification of the equipment is defined in the RPV
configuration. This information is read of the EQUIPMENT >
IDENTIFICATION
Shows the equipment model and firmware version to
which the configuration refers
C Buttons to send or receive a configuration to or of a piece of equipment, to import or export a configuration
to or of a file, to edit or remove an equipment configuration which is locally stored, and to convert an older
version configuration for a newer version (the Convert button is applicable only for the model RPV-310).
Before using the Configuration Tool it may be necessary to install a plug-in file related to the firmware
version installed on the equipment.
2.3.2 PLUG-IN
Every equipment model and firmware upgrade has a new plug-in file to incorporate the changes to the
Configuration Tool.
The plug-in file is available with the firmware release.
Installation of the plug-in file is mandatory for any equipment model and firmware version that is to use this
tool.
To install the plug-in, do the following:
1. Double click on the plug-in file (example: rpv310-software.plugin. install-en-21A00).
2. Select the checkbox with the text to Accept the agreement license terms and click on the Installbutton.
Wait for installation to be completed and then click on the Finish button.
See C:RPVconftoolresoursesplugins to check which plug-ins are installed.
To Next Page
Loading...