Figure 82: Screen to configuration on the SCL file
The OK button is to confirm the changes in the files list. The CANCEL button is to cancel the changes.
The ADD FILES and REMOVE FILES buttons are used to add or remove a file of the list of IED
configurations, loaded onto the initial screen.
When a file is removed, it is necessary to know that the configuration files are not modified. It is not possible
to view the GOOSE CONTROL BLOCK, associated with an input if the file is removed, however the
configuration of the digital input of the RPV remains active.
o Association between GOOSE messages RPV digital inputs
To associate a GOOSE Control Block to a digital input, do the following:
Initially select an element GOOSE binary of the GOOSE Control Block list, obtained of the SCL files
generated by IED;
Select one of the 320 RPV digital inputs according to GOOSE;
Click on the button to make association between the GOOSE message and the previously selected RPV
digital input;
The message indicating the operation will show in the status area;
To remove the association click on the disassociation button.;
The user can only associate a GOOSE CONTROL BLOCK with a digital input if the data is compatible with the
permitted limits on GOOSE. An example of a combination of GOOSE CONTROL BLOCK with a digital input.
It is possible to associate a GOOSE CONTROL BLOCK with a digital input only if the data is compatible with the
permitted GOOSE message data. An example of association of a GOOSE CONTROL BLOCK with a digital
input is shown in Figure 83.
To Next Page
Loading...