Alstom Reason RPV311 - RPV Manager Settings

Chapter 13 – RPV Manager
RPV311
RPV311-TM-EN-6
235
The procedure to activate the Auto Polling can be seen in the Settings Menu 3.2.2.
 Manual Download:
 Selected records:
Select the records required, and click the button “Get Selected”;
 All records:
Click "Get All".
Double click on the downloaded record to open (it is necessary to have a software to open .zic files already
installed).
To close this window use the close button in the top right, or use File >Exit.
A confirmation message will be shown after closing.
3.2 RPV MANAGER SETTINGS
RPV Manager presents some settings that user can access through the menu bar. These settings are shown
below.
3.2.1 FILE MENU
In the File menu, the user can:
 Open COMTRADE folder;
 The Open containing folder option will open the default register's downloaded folder.
By default, the folder is C:\RPV\Records.
 , Refresh All Devices.
 Refresh the list with COMTRADE files (but does not download them);
 Refresh Alarms tab;
 Check alarms to send email/fax when new ones are exist;
 Compares the local configuration file with the respective RPV311 configuration file.
 Close the software with the "Exit" option.
3.2.2 SETTINGS MENU
In the Settings menu, the user can:
 Create, edit and remove Installations;
 Create and remove Devices;
 Transmission line configuration for TW fault location;
 Create, edit and remove contacts for e-mail and fax sending;
 Create, edit and remove Warnings to be sent.
Signing up RPVs to the RPV Manager: