Alstom Reason RPV311 - Page 343

RPV311
Chapter 18 – Wiring Diagrams
RPV311-TM-EN-6
343
203
Default configuration reestablished by
local interface
Default settings reset via the local interface
210
Default access reestablished by local
interface
Factory set access password reset at local
interface
211
Default access reestablished
The default parameters to access the
equipment was reestablished
250
Firmware upgrade [revision: ]
Firmware upgrade indication
280
Link down
The link connection was down
281
Link up
The link connection was up
282
Thresholds related to inputs of link
disabled
The thresholds related to inputs of the link was
disabled
283
Thresholds related to inputs of link
enabled
The thresholds related to inputs of the link was
enabled
284
All links up
All the links was up
290
Acquisition module calibration date
[slot:%p; date:%p]
Date of the acquisition module calibration
291
Unused acquisition module [slot: ]
Exist an unused acquisition module
292
Unused conditioning module [slot: ]
Exist an unused conditioning module
293
Missing acquisition module [slot: ]
An acquisition module was missing
294
Missing conditioning module [slot: ]
An conditioning module was missing
295
Invalid acquisition module [slot: ]
Exist an invalid acquisition module
296
Invalid conditioning module [slot: ]
Exist an invalid conditioning module
300
Invalid Ethernet cross-trigger
Ethernet cross-trigger communication was not
validated by equipment
350
Operation user access via web [user: ;
source: ]
Start of operation user access
351
Operation user access logout via web
[user: ; source: ]
End of operation user access