Chapter 4 – Configuration
C The TRIGGER LOGIC field contains all the thresholds created. The logic equation uses AND and OR logic
operators over previously defined thresholds. Initially, all preset thresholds are displayed as implicit OR
operators, one per line.
To enable thresholds individually, click on the threshold and select ENABLE;
To disable discarded thresholds individually, click on the threshold and select DISABLE;
To break or remove complex thresholds, click on the threshold and select CUT LAST;
To create equations with AND operators, follow the procedures below:
o Click on the threshold and select Cut last;
o Click on the threshold to which is desired to add the previously selected threshold and then
select the threshold to be added.
D Selecting the RECEIVE ETHERNET CROSS-TRIGGER or SEND ETHERNET CROSS-TRIGGER check box enables
these features. It allows the start of the recording of an exceeded threshold by Ethernet cross-trigger.
E The RATE scroll box allows user to select the rate on the fault recorder (64, 128, or 256).
10.2 CONTINUOUS RECORDING
In this section, shown in the figure below, is possible to configure the equipment's continuous recorder.
Figure 32: Fault recorder – continuous recording configuration section
To Next Page
Loading...