Page 5 of 22
CHANGING THE LNB SETTING
Press the MENU button to launch the menu, then.
Navigate to the following menu screens:
Advanced Options
Installation setup
Enter the setup pin (The default is 1234)
LNB setup
Select the LNB type by pressing OK to select first item and using left and right to scroll. Press OK again
to deselect the option.
Enter in the correct LNB value by pressing OK on the LNB Frequency option and then enter the new
LNB value, then press OK again to deselect the option.
Press OK on the “Accept these settings” button.
You will be returned to the Satellite installation menu.
Press OK on “Satellite Rescan” to rescan the decoder with the new LNB settings.
Install & Connect the DSD 4121 Decoder
To Next Page
Loading...
General