ALTUS AL40L 4950 4B - Detailed Channel Settings; Analogue Channel Tuning

50 / 57 TR
Television / User Manual
DETAILED CHANNEL SETTINGS
----------------------------------------------------
Tuning analogue television chan-
nels
This setting is only necessary if you have not
carried out an analogue search during the first
time installation.
The television channel can be set directly or
using the search.
Switching the television to analogue
channels
Note:
7
Analog channels can only be selected
while »Air« or »Cable« sources are active.
1 Open the »Input Source« menu with »
«.
2 Select »ATV« using »
V « or » Λ « and con-
firm with »OK«.
Note:
7
Additional operations are explained in the
following sections.
Re-tuning all analogue television
channels
Note:
7
Plug the rooftop antenna cable (for ana-
logue television stations) into the RF IN T2
socket on the television.
1 Press »MENU« to open the menu.
2 Press »
<
« or »
>
« to select the »CHANNEL«
menu and press »OK« to confirm.
– »CHANNEL« menu is now enabled.
3 Select »Auto Tuning« with »
V « or » Λ « and
confirm with »OK«.
– »Tuning Setup« menu will be displayed.
MENU ENTER
Tuning Setup
Back Start
Tune Type ATV
Country Turkey
Symbol Rate Auto
Frequency Auto
Network ID Auto
Scan type DVB-T
Scan Type Full
4 Select »Tune Type« with» V « or » Λ « and
select »ATV« with »
<
« or »
>
«.
5 Go to »Country« with »
V « or » Λ « and
select the country with »
<
« or »
>
«.
6 Press »OK« to start the search.
– The »Channel Tuning« menu will be
displayed and the search for TV channels
will start.
– Search may take several minutes depend-
ing on the number of television channels
received.
Note:
7
The search can be aborted with »EXIT«.
7 Press »EXIT« to end searching.