PXB Parallel Straightedge Board
Instructions
Follow this recommended sequence when making adjustments to the position of the straightedge blade.
To Set Brakes for Optimum Braking Strength
Unscrew brake knobs as far as they will go.
Retighten brake knobs one full revolution only.
Loosen top adjustment knobs.
Push metal side brackets toward the center until
both brake pads rest against edges of board.
Retighten top adjustment knobs.
Brakes are now set and ready to use. Simply
tighten and loosen brake knobs as necessary.
Be sure to keep top adjustment knobs tightly
secured or the brakes will not function.
To Set Straightedge Blade Parallel to Edge of Board
Loosen one wire capture screw on either side of the blade.
Pivot the blade until it is in the desired parallel position.
Retighten wire capture screw.
To Replace or Reset the Wire
Blade should be positioned in center of board when rewiring
and spring should be centered.
Attach eyelet to one end of wire and connect eyelet to spring.
Thread wire around pulleys as shown in diagram (
B
).
Extend spring approximately 1" beyond unstretched length.
Secure wire to second eyelet and trim excess.
1
1
1
2
2
2
3
3
3
4
4
5
5
6
7
PXB Boards are available
in the following sizes:
PXB21 16" x 21"
PXB24 18" x 24"
PXB26 20" x 26"
PXB31 23" x 31"
PXB36 24" x 36"
PXB42 30" x 42"
Spring rides
on top of wire
Side
Bracket
Brake
Knob
Brake
Pad
Wire
Capture
Screw
Wire
Board
Top
Adjustment
Knob
Straightedge
Blade
Diagram A
Diagram B
To Next Page
Need help?
General