Amada AMFS02 - Page 5

4
Install the metal frame with shelf using 2 pcs long lag screws [A] and 2 pcs short lag
screws [B]. Tighten lag screws [A]/[B] with the screwdriver(not included). If you feel it
is difficult to install the long lag screws [A] to the wall, you can simply use a
2mm(5/64 in.) drill bit to drill 2 pilot holes, Tighten the lag screws [A]/[B] only until
they are pullled firmly against the metal frames.
C
A
B
C
A
B
X
For wood stud mounting,
wall anchors [C] and [D]
are not necessary.
WARNING:
X
C D
2 in.(50mm)
For Long Lag Screw
ø5/64 in.(ø2mm)
[Not Included]
[Optional]
Option A
Option B
Note:
The floating shelf will be
easier to falling off for pulling
tension if you install the
floating shelf up side down
Note:
The floating shelf will be
easier to falling off for pulling
tension if you install the
floating shelf up side down