Assembly Instruction
Step 1: Put the hollow ring set in the swivel head.
Step 2: Fix in the card slot on the top of the swivel head.
Step 3: Knob tightly the hollow ring up to the bottom of the card slot.
Step 4: Insert clasp into the card slot, please try to find the best cut on both
- sides if you install it for the first time.
Step 5: Insert the screw head at the top of the card slot, and align the hole.
Step 6: Put the fixation pin in the hole and knob to tighen it.
Step 7: Align the iron tube with the desk clamp and knob to tighten.
Step 8: According to the thickness of your table, turn knob with long screw to
- proper position.
Step 5 Step 6
02
To Next Page
Loading...