Observe
these
safety precautions
to
prevent
injuries
and accidents.
G
uard
against
the
springing
up
of
work
if
it
is
oversized.
N
ever
exert
pressure
on
tools
exceeding
the
allowable
pressure
shown
on
each
tool
-
in
order
to
prevent
tool
breakage
and
the
resulting
danger.
When 2V dies are used, use the
V-groove on the rear side of the
machine for additional safety.
B
e
sure
to
confirm
that
punch
and
die
clamp
bolts
are
‘firmly
tightened.
When work must be bent at tin acute
angle, punches may bite into dies and
they may be dislodged and fall from the
machine.
vii
To Previous Page