GENERAL DESCRIPTION Chapter 1 3/20
OPERATOR’S MANUAL HFE M2 – X41176B Issue 05/2010
1.1. DESCRIPTION
The purpose of this document is to facilitate the installation of your High Fidelity hydraulic
press brake (Fig. 1.1) and its connection to the electrical and pneumatic supply systems.
This product line includes the following models:
- HFE M2 50 to 400 tons
Depending upon the models, lengths start 1.2 meters up to 6 meters
Our models are supplied:
In a « basic » footswitch-controlled version,
Equipped with a “A” or “B”-type back gauge (except with 5012)
Equipped with a “C”-type back gauge (only with 5012)
Equipped with a « HA 5 axes », « HA 2 axes » (only with 320 and 400 T) -type
back gauge
in option :
- light curtain, which is used as front protection and as an operation cycle control
device.
Or
- laser safety system used as front protection only.
Note : In this manual, “tons” is very often used instead of international measurement
unit “kN”. We remind you that 9.81 kN is equivalent to one ton.
To Next Page
Loading...