Amada HFE M2 - Page 8

8/12 CONTENTS
Issue 05/2010 OPERATOR’S MANUAL HFE M2 – X41176B
6. OPERATION........................................................................................................................ 1
6.1. START-UP ...................................................................................................................... 2
6.2. DESCRIPTION OF CONTROL UNITS......................................................................... 3
6.2.1. NUMERICAL CONTROL PANEL.......................................................................... 3
6.2.2. DESCRIPTION OF CONTROL AND SIGNALLING DEVICES........................... 4
6.3. OPERATION (WITHOUT LIGHT GUARD) ............................................................. 10
6.4. USE OF THE LIGHT GUARD..................................................................................... 12
6.4.1. SWITCHING ON.................................................................................................... 12
6.4.2. ALTERNATE PROTECTION MODE .................................................................. 13
6.4.3. PROTECTION MODE AND « SINGLE PASSING-THROUGH » CYCLE
CONTROL. ....................................................................................................................... 15
6.4.4. PROTECTION MODE AND « DOUBLE PASSING-THROUGH » CYCLE
CONTROL. ....................................................................................................................... 16
6.4.5. PROTECTION MODE AND « SIMPLE PASSING-THROUGH » CYCLE
CONTROL. ....................................................................................................................... 17
6.4.6. PROTECTION MODE AND « DOUBLE PASSING-THROUGH » CYCLE
CONTROL. ....................................................................................................................... 19
6.5. MACHINE EQUIPPED WITH A FRONT PROTECTION BY LASER..................... 21
6.5.1. INITIAL SETTINGS............................................................................................... 21
6.5.2. STOPPING DISTANCE TEST............................................................................... 21
6.5.3. TROUBLESHOOTING - MESSAGES.................................................................. 22
6.6. DISPLAYS .................................................................................................................... 23
6.7. USB KEY....................................................................................................................... 26
6.8. MACHINE INITIALISATION ..................................................................................... 27
6.9. PROGRAMMING......................................................................................................... 29
6.9.1. PRELIMINARY NOTE CONCERNING PROGRAMMING................................ 29
6.9.2. “MANUAL 1” SIMPLIFIED PROGRAMMING “PROGRAMMING MODE”... 30
6.9.3. “MANUAL 2” MODE: "ANGLE PROGRAMMING" OR "X-ALPHA".............. 35
6.9.4. GRAPHIC MODE PROGRAMMING ................................................................... 42
6.9.5. MULTI-PROGRAM MODE................................................................................... 54
6.9.6. SEMI-AUTOMATIC MODE.................................................................................. 56
6.9.7. AUTOMATIC MODE ............................................................................................ 59
6.9.8. TEACHING MODE................................................................................................ 62
6.10. EDIT MENU................................................................................................................ 65
6.10.1. PUNCH EDIT ....................................................................................................... 65
6.10.2. PUNCH HOLDER EDIT ..................................................................................... 67
6.10.3. DIE EDIT .............................................................................................................. 68