Installation & Operation Guide Page 20 of 48
Table 0-2 Fingerprint Enrollment Hints
Fingerprint is too dry or dirty.
Wipe finger, and/or moisten.
Place finger firmly and flat on the
sensor.
Use the finger alongside your thumb.
Select fingers that are not worn or
injured. If the fingers are small, use the
thumb.
Place at least 2/3 of the finger firmly on
the sensor. Do not touch the finger too
fast and do not move the finger on the
sensor until prompted.
Re-enroll your finger if your fingerprint
changes as a result of an injury, etc.
Use password registration as an
alternative for people with poor quality
fingerprints. Also, the threshold setting
can be reduced.
Enrollment is the procedure to associate a User ID with a fingerprint by scanning a user's finger three (3) times to create a
template (see figure).
Finger Template Creation
Note: Enrolling more than two (2) fingers per user might adversely effect the amount of user templates that can be
stored in the fingerprint reader
To Next Page
Loading...
