Installation & Operation Guide Page 23 of 48
Note: The system may prompt you with voice and on screen warnings if errors in the FP enrollment process occur.
For example, if that ID already has the same finger enrolled, the voice prompt will say "Duplicate Finger" while
the screen will display "FP Enrolled Alrd" [for fingerprint enrolled already].
Note: The system will not allow duplicate enrollment of the same finger for the same or different User IDs. You must
enroll a different finger.
a) After the 3
rd
successful finger press, the display will show the User ID followed by “xx” (see figure) to
indicate that one (1) finger template exists for this ID.
Save User ID with FP Template
b) Press OK to save the finger template, and enroll a backup finger or ESC to enroll a new user.
8. Card Reader Terminal
a) If enrolling card (note only available on card terminal) Press Up or down keys to select (▲▼) “Enroll
Card” and press enter (M/┘).
b) Swipe (Mag-stripe or Barcode card depending on MTX-30 model) or present proximity card approximately
half inch from reader (proximity MTX-30 terminal)
Note: When finished entering PWD, FP or card, please ensure to select OK (M/┘) to save employee
To Next Page
Loading...
