Installation & Operation Guide Page 28 of 48
Date Fmt: Date Format
Time format: Time format displayed on the initializing interface of fingerprint sensor
Press / to select format. The fingerprint sensor supports ten date format: YY-MM-DD, YY/MM/DD, YY.MM.DD, MM-
DD-YY, MM/DD/YY, MM.DD.YY, DD-MM-YY, DD/MM/YY, DD.MM.YY and YYYYMMDD. Select your desired date format.
Keybeep: Keyboard beep: Press / to set whether the key has sound or not. “Yes”
Voice: Voice prompt: Press / to select whether to give voice prompt or not. The device will give corresponding voice
prompt during operation.
Vol.: Press / to adjust volume.
Recheck Min: It is in the set time range unit (minute). If an employee’s attendance record has been recorded already there, then
the record of a second attendance won’t be saved. (Effective value is 0-60 minutes. 0 means all the records after
verification are saved.)
DATA MANAGEMENT
Delete Att Log: Delete all attendance records.
Delete All: Delete all enrolled employees’ information, fingerprint and attendance record.
Delete Admin Role: Change all administrators into common users.
Clean Dept.: Delete all Departments
UPDATE = ONLY USE IF ADVICED BY AMANO SUPPORT STAFF.
DISPLAY
Display Setup – allows configuration of the match retry times and password retry times.
To Next Page
Loading...
