Installation & Operation Guide Page 37 of 48
Software Setup for Connection Type
Step 9. In the Connection field, select the type of connection you are using to communicate with the MTX-30
terminal(s). The required information in the Connection Info depends on your connection.
Ethernet: The MTX-30 terminals communicate to the Host PC via Ethernet connection. If selected, you
must enter the IP Address and Port 4370. [Obtain the correct IP address from your network administrator],
or alternatively, please consult Chapter 3: Network Configuration of this Guide for additional information
about hardware configuration].
Note: Default Port number for Ethernet terminals are; (Do not change default ports)
MTX-15 = 2101, MTX-10 & 20 = 401, MTX-30 = 4370, and HandPunch’s = 3001.
Direct: The MTX-30 terminal(s) are directly connected to the Host PC via Com Port. If selected, you must
select the Com Port only .
Step 10. Click on the Terminals tab to add, edit, delete, or communicate with MTX-30 terminals.
Setup for Locations with Terminals Tab
Step 11. The Ethernet and direct connection MTX-30 terminals in this location should appear in the Terminals list (see
figure).
Step 12. Double-click on the found terminal or highlight the terminal and click on the Add button to add a new Terminal
to the Location and the Terminal window General tab will appear for setup.
To Next Page
Loading...
