Page 44 of 48 © Copyright 2015 Amano McGann, Inc. 7000_Operations_06302015
6. Take the vault to the drop-off location once the vault has been removed.
7. Flip the vault over so the “OPEN” switch is on top.
8. Insert the ‘68’ key into the lock, push in the key and simultaneously rotate
the key towards the vault front/vault hand until the key stops.
9. Rotate the OPEN switch in the direction of the arrow/counter-clockwise.
10. Pull off the top of the vault and unload the money.
11. Follow the previous steps in reverse order to re-insert the vault into the
Paystation.
8.3 Loading Receipt Printer Paper
1. Open the Paystation door.
2. Power the Paystation ON.
3. Pull out the receipt printer drawer.
4. Place the receipt paper roller into the receipt paper spool.
5. Insert both roller and paper into the receipt drawer behind the receipt printer
6. Place the roller ends in the diagonal rails.
7. Once the receipt roll is in place, feed the end of the receipt paper beneath
the receipt tension bar and into the back of the receipt printer. The receipt
printer automatically grabs the paper after the proper sensor is triggered.
[Fig. 8.3A]
To Next Page
Loading...
