Page 45 of 48 © Copyright 2015 Amano McGann, Inc. 7000_Operations_06302015
8.4 Removing the Coin Hoppers
IMPORTANT: Only remove the coin hoppers for troubleshooting
purposes. Removing and dumping the coin hoppers is not the
correct inventory procedure
1. Open the Paystation door
2. Power OFF the Paystation.
3. Insert the 68 key into the middle coin dispenser lock. Push the key in and
simultaneously rotate the key 90 degrees to the left/counter-clockwise.
4. Pull the coin door open and pull the coin hopper drawer handle until the coin
hopper drawer is fully extended.
5. Disconnect the cable on the front of the coin hopper
6. Push down on the handle and simultaneously tilt the hopper upwards. The
hopper will tilt to a 45 degree angle and stop.
7. Pull the hopper horizontally towards the right side of the Paystation to slide
the hopper out of its rails.
[Fig. 8.4A] Press the tab down, tilt the hopper, and pull the hopper out
To Next Page
Loading...
