12 13
]Machine assembly[
]Machine assembly[
Device Holder
Device Holder Parts:
How to Assemble the Device Holder:
1.
Begin with inserting the ball
at the end of part
2
into the
protruding piece on the back
side of part
1
and twist to
tighten it in place.
2.
Attach the now-constructed
device holder by holding
it in place at the position
and height you desire on
the microphone pole. After
placing the round claw piece
on part
2
around the pole,
shut its clasp to tighten and
fasten it.
4.
Attach both microphone clips
4
to each of the bendable
arms
3
by twisting them
tightly into place.
5.
Place the microphones into
the microphone clips
4
.
6.
Adjust the height of the
microphone pole
1
as
desired by twisting the two
knobs on the pole.
1 2
To Next Page
Loading...
