Bismarck
141
738 Glue piece 1239 (with the two holes) to rail 1236 and piece 1240 (with one hole)
on the side opposite the other rail 1236. Bend the railing of gangway 1241 to 90°.
741 Assemble walls 1247, 1248 without glue in the joints of piece 1246
and walls 1250, 1251 in piece 1249 as shown in the picture. Glue them
after you have checked the correct position. Warning: the two structures
are not the same; ensure to correctly orient the pieces.
740 Now prepare the stern signal station with the pieces represented in
the picture and which you can nd on sheet 1559.
737 Assembled in the central joint of base 1234 and support 1235 (see detail). Ar-
range the two rails 1236 symmetrically and glue supports 1234-1235, 1237, 1238 in
the joints.
739 Complete the rst structure, that of the starboard side, by gluing gangway 1241 to the lateral joint of
the structure. With as many pieces from 1234 to 1240, create a second structure mirroring the previous one.
For this structure, you will have to use the gangway 1242. Observe carefully the picture above to identify the
exact position of the elements. The holders for the connection motor boats are ready; keep them aside as they
will be xed to the stern superstructure after the painting steps.
736 Now prepare the holders for the connection motor boats. Remove the elements
shown in the picture from sheet 1559 and lay them on your worktop in the order
presented. Identify the longer end of rails 1236, (red arrows), it indicates the position
of support 1238.
736
739
737
740
738
741
1236
1240
1240
1239
1241
1240
1236
1238
1238
1237
1237
1236
1236
1236
1239
1239
1241
1242
1245
1245
1250
1250
1249
1249
1251
1246
1247
1248
1246
1251
1248
1247
1241
1237
1237
12391239
1240
1240
12381238
1234
1235
1235
1234
1236
1236
1234
1234
1235
1235
1235
1234
To Next Page
Loading...