EN
5
» Check the appliance for transport damages.
» Clean the appliance before rst use.
» Before connecting the appliance to the power supply, check that the power supply
voltage and current rating corresponds with the power supply details shown on the
appliance rating label.
5. Assembly
1. Align the pulp container (12) with the lug at the bottom of the main body (10). Hold
the pulp container in place. Place the spout housing (5) over the main body, ensuring
the lip of the spout housing hooks onto the pulp container to secure it (Fig. 1).
2. Hold the sides of the rotating sieve (4) and rotate it until it aligns with the drive shaft
(11) on top of the main body (10). Push the rotating sieve (4) down until it locks in
place (Fig. 1).
1
1
2
3
To Next Page
Loading...