Device Care and Use
Keep the Amazon Monitron Sensor dry.
This device has IP65 rating and should not be immersed in water or other liquids.
If the device is dropped or otherwise damaged, the device may be compromised when exposed to water.
Do not expose the device to pressurized water, high velocity water, or extremely humid conditions.
Do not spill any abrasive substances on the device.
Don’t expose the Amazon Monitron Sensor to extreme temperatures.
Do not expose this device to extreme heat or cold. Store the device in a location where temperatures remain
within the storage temperature ratings set forth in the quick start guide. The device is designed to function within
the operating temperature ratings set forth in the quick start guide. If it is too hot or too cold, the device may not
turn on or function properly until it has warmed or cooled, as the case may be, to within the applicable
temperature ratings.
To reduce the risk of electrostatic discharge upon contact with this device, avoid such contact in extremely dry
conditions.
Service Your Device
If you suspect the device is damaged, discontinue use immediately and contact Amazon Customer Support.
Contact details can be found at aws.amazon.com/monitron/terms/. Faulty service may void the warranty.
USING THE DEVICE AROUND OTHER ELECTRONIC DEVICES
The device generates, uses, and can radiate radio frequency (RF) energy. If not used in accordance with
instructions, may cause interference to radio communications and electronic equipment. External RF signals may
affect improperly installed or inadequately shielded electronic operating systems, entertainment systems and
personal medical devices. While most modern electronic equipment is shielded from external RF signals, if in
doubt, check with the manufacturer. For personal medical devices (such as pacemakers and hearing aids), consult
your doctor or the device manufacturer to determine if they are adequately shielded from external RF signals.
Innovation, Science and Economic Development Canada (ISED) Compliance
This device contains license-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic
Development Canada’s license-exempt RSS(s). Operation is subject to the following two conditions: 1) This
product may not cause interference; and 2) This product must accept any interference, including interference that
may cause undesired operation of the product.
Information Regarding Exposure to Radio Frequency Energy
This product complies with IC RSS-102 RF exposure limits set forth for an uncontrolled environment. This device
should be installed and operated with a minimum distance of 20 cm between the device and your body.
CAN ICES-3 (B)/NMB-3(B)
To Next Page
Loading...
Need help?
General