7
Operation
Batteries (if included) are not charged upon shipping. They must be
charged prior to first use.
Charge only Ni-MH type rechargeable batteries in this charger.
Batteries may leak or explode causing personal injury if inserted improperly,
disposed of in fire, mixed with other battery types, or short-circuited.
1. Insert 2 or 4 AA/AAA rechargeable Ni-MH batteries into the battery compartment;
batteries must be charged in pairs. For charging only 2 cells, insert the batteries in the
left or right side of the charging terminal (Figure 1) and (Figure 2).
2. Make correct contact as indicated by the polarity symbols (+ and -) marked inside each
compartment.
3. Charge either AA or AAA sizes at a time. Do not mix battery sizes when charging.
4.
Plug the charger into a standard AC mains outlet. The Green USB status LED will light within
10seconds, the Green USB status LED will turn off and the Red LED will glow for each
slot where a battery is charging. The LED lights to show that the batteries are charging.
5. When the batteries are fully charged, the Red LED will turn off to indicate that the charge
is completed and batteries are ready for use. When the Green LED light is on, the USB
port is ready for use.
WARNING
WARNING
WARNING
To Next Page
Loading...
Need help?
General