11.13.2 Using automatic part-width section control
11.13.2.1 Activating automatic part-width section control
GPS switch can be operated in manual mode and in
automatic mode. In automatic mode, the automatic
part-width section control is enabled.
When the part-width sections are driven over the
following boundaries, the part-width sections are
automatically switched on and off.
Field boundary
Boundary from the worked to unworked area
Headland boundary
The recording of the worked areas starts when the
part-width sections are switched on, and stops when
the part-width sections are switched off.
REQUIREMENTS
The AMABUS implement or ISOBUS
implement is connected
The connected implement is configured for
automatic part-width section control
The activated mode is shown on the map
.
When manual mode is enabled,
select in the GPS switch menu.
Automatic mode is enabled. The part-width
sections are automatically switched depending on
the desired overlap.
CMS-I-002000
CMS-T-00004693-A.1
CMS-T-006234-B.1
11 | Using the GPS switch
Using part-width section control
MG5560-EN-II | E.1 | 21.04.2020
111
To Next Page
Loading...
Need help?
General
