The setpoints for the application/spread rates can
come from the following sources:
Setpoints created on the AMATRON 3
From an imported application map in shape format
From an external device using the ASD interface
REQUIREMENTS
Job is started, see page 64
If the setpoint should be taken from the master
data:
Setpoints are created in the master data, see
page 67
If the setpoint should be taken from an
application map in shape format:
Application map in shape format is imported,
see page 122
If the setpoint should be transmitted with the
ASD interface:
ASD interface is configured, see page 28
1. "Jobs" > Select the started job.
CMS-I-002248
10 | Using the job management
Editing jobs
MG5560-EN-II | E.1 | 21.04.2020
56
To Next Page
Loading...
Need help?
General
