10
Information about the computer
AMATRON II-A DB 599 09.01
3. Description of product
3.1 Description of system
The AMATRON II-A can be used as a fully automatic
controlling device on fertiliser spreaders and field
sprayers. The device allows an area specific spread
rate control depending on the pre-set desired values
and in relation to the actual forward speed and work-
ing width.
The actual application rate, the total amount and the
residual amount is determined via AMATRON
II-A.
In addition the actual forward speed (km/h) is dis-
played and the worked part area (ha), the worked
total area (ha) and the operating hours (h) per job are
determined and stored.
Filling the field sprayer’s tank with a filling device
(tank meter) or by pressing a key (tank full) has been
automatically registered. When an electronic pres-
sure sensor is installed the spray pressure is moni-
tored and displayed.
AMATRON II-A displays the actual tank contents,
and, after the "start function", determines the applica-
tion rate in kg or litres and sends a visual and audible
alarm when the hopper/tank is getting empty at a pre-
set alarm limit.
The application rate can be adjusted in 10 % steps.
The unit consists of the computer (1), the console
(10-14), and the tractor signal distributor (16) with
the sensor drive shaft/wheel (20) for distance de-
termination.
F
A radar sensor for a slip free determi-
nation of the speed may be installed.
The tractor signal distributor (16) with its connec-
tion to signal socket tractor (22) does not contain
any sensors. The signals are taken from the tractor
signal socket.
The field sprayer is connected with AMATRON II A
with the switch box via the implement plug.
F
The AMATRON II-A can also be used
as a hectare counter. The sensor Y
(operating position) (18) is connected
with the signal distributor (16) by us-
ing a 3-pole plug.
To Next Page
Loading...
Need help?
General
