Amazone AMATRON II-A User Manual

24
Operating sequence fertiliser spreader ZA-M
AMATRON II-A DB 599 09.01
one job) (Fig. 11/1) After pressing key
=
Eingabe
Input
the
entered value is stored.
F
Enter the value for the desired spread
rate with the vehicle stopped.
F
During fertiliser spreading the spread
rate can be adjusted via the keys
-10 %
+10 %
in +/- 10 %-steps (please
refer to para. 6.5.4).
• By pressing key
T2
(Start), you will get into
the display "Start job?" (please see para. 6.3.1).
• By pressing key
T4
(Next), a comment can
then be filed in the data block "job" (see para.
6.1.3).
6.1.3 Menu "Comment"
Fig. 12
Here you can file a comment (Fig. 12/1), e.g. de-
tails about the weather etc. Entering via the 10-digit
key board (see para. 6.1.1). Name and comment
are not necessary for the operational procedure,
however they ease the later reading and assign-
ment of data.
Also in this case the data are only stored by
pressing the input key.
• By pressing key
T2
(Start) the job can be
started also from here. Automatical change into
the operational data.
• By pressing key
T4
(Next) now the imple-
ment serial number is displayed (please refer to
para. 6.1.4).
6.1.4 Menu "Implement serial number"‘
Fig. 13
With the initial operation of the machine (Fig. 13/2)
the implement serial number (Fig. 13/1) is auto-
matically issued and will later on be automatically
selected, i.e. no entry is necessary.
If different implements of the same type are con-
nected with AMATRON II-A (e.g. a second fertiliser
broadcaster with different implement data), the
individual machines must receive different imple-
ment serial numbers (e.g. enter the next free num-
ber for the second spreader).
After connection the second spreader can be acti-
vated by entering its serial number via the ten digit
key board.
• By pressing key
T1
(Menu) and key
T4
(Next) return to the menu selection.
• Start the job by pressing key
T2
(Start).
However, beforehand enter the necessary data
into the data block "machine" as otherwise error
messages would occur (see para. 6.6).
• By pressing key
T3
(Delete) all data can be
deleted. Corrections are also possible while
entering via key
C
.
F
It is useful to select in the menu se-
lection now the data block "machine"
via the key
T3
in order to enter the
required data for the job (see para.
6.2).

Amazone AMATRON II-A Specifications

General

Brand	Amazone
Model	AMATRON II-A
Category	Desktop
Language	English