Amazone AMATRON II-A User Manual

34
Operating sequence fertiliser spreader ZA-M
AMATRON II-A DB 599 09.01
In this menu also the PTO shaft speed (Fig. 45/3)
(only with additional PTO shaft sensor) can be
monitored.
Fig. 45
• By pressing key
T4
(Next) you may return to
the actual operational display.
6.5.4 Key: Change of application rate
With the keys
+10 %
and
-10 %
it is possible to in-
crease or reduce the application rate in the opera-
tional display (please refer to para. 6.3.2) whilst
travelling.
Fig. 46
• By pressing key
T4
the individual shutter
slides (r.h. or l.h.) or both shutter slides (‚% total
–
T4
) are dialled.
By pressing key
+10 %
the total amount can be
increased by 10 %. An additional pressing of the
key will increase the application rate by 20 % etc.
Increases up to 90 % are possible.
By pressing key
-10 %
the application rate can be
reduced or the pre-set value can be set again by
once pressing key
100 %
.
This also applies for key
-10 %
in the reverse order.
For the individual spreading sides a spread rate
change is also possible after the right or left hand
shutter slide has been dialled.

Amazone AMATRON II-A Specifications

General

Brand	Amazone
Model	AMATRON II-A
Category	Desktop
Language	English