Cleaning, maintenance and repai
166 KE/KX/KG (RIGID) BAH0089-7 02.2020
12.15.4 Installing and removing hydraulic hose lines
When installing or removing hydraulic hose lines, be sure to observe
the following instructions:
Use only genuine AMAZONE hydraulic hose lines!
Ensure cleanliness.
As a matter of principle, you must install the hydraulic hose lines
such that, in all implement situations,
There is no tension, apart from the hose's own weight.
There is no possibility of compression for short lengths.
Outer mechanical influences on the hydraulic hose lines are
avoided.
Use appropriate arrangements and fixing to prevent any
scouring of the hoses on components or on each other. If
necessary, secure hydraulic hose lines using protective co-
vers. Cover sharp-edged components.
the approved bending radii may not be exceeded.
When connecting a hydraulic hose line to moving parts, the hose
length must be appropriate so that the smallest approved bend-
ing radius is not undershot over the whole area of movement
and/or the hydraulic hose line is not over-tensioned.
Attach the hydraulic hose lines onto the specified attachment
points. There, avoid hose clips, which impair the natural move-
ment and length changes of the hose.
It is forbidden to paint hydraulic hose lines!
To Next Page
Loading...
Need help?
General
