Remote Control &Touch Panel Operation
BUTTON FUNCTION ACTION & INDICATION
POWER
ON: Enables control panel functions and
remote control. Turns on flame effect.
OFF: Disables control panel functions and
remote control. Turns off flame effect.
1.
Press once. Indicator light turns on.
Power turns on. All functions
enabled.
2.
Press again. Flame effect turns off. Unit
goes to standby. All functions turn off.
TIMER
TIMER button: Controls timer settings to
turn off fireplace at selected time.
Settings range from 0.5 hours to 8 hours.
1.
Press once. Indicator light turns on.
Timer is set to 0.5 hours.
2.
Press again until desired setting is
reached. Indicator lights show setting.
FLAME
FLAME button: Makes flame effect
dimmer and brighter.
NOTE: Flame effect stays on until power
button is turned off. Flame effect must be
on for heater to turn on.
1.
Press once. Flame brightness effect
gets changing.
2.
Press again. until desired setting is
reached.
COLOR
COLOR button: Changes the color of
the flame effect.
NOTE: color effect stays on until power
button is turned off. Color flame effect
must be on for heater to turn on.
NOTE: The fireplace will remember
color selection.
1.
Press once. Flame color changes.
2.
Press again until des
ired setting is
reached.
HEATER
HEATER button: Turns heater on and off.
NOTE: The heater only works when the
flame effect is on. If the flame effect is off,
the heater will not turn on.
NOTE: To prevent overheating, the heater
fan will blow cool air for 8-10 seconds
before the heater turns on, and after the
heater turns off.
1.
Press once. Indicator lights up.
Fan blows cool air for 10 seconds. 750W
heater turns on and blows warm air.
2.
Press again. Indicator lights up.
1500W heater turns on and blows hot air.
3.
Press again. Heaters turn off.
The fan blows cool air for 10 seconds to
allow heater to cool down, then turns off.
To Next Page
Loading...
