AMC Secuquick softline - Care and maintenance; 4.1. Disassembling the Secuquick softline; 4.2. Cleaning and storing the Secuquick softline

28 29
Press lightly on the Visiotherm with one hand, and close the knob with the other. Turn the rotary knob to
the stop without forcing it. The yellow marking must no longer be visible.
3.3. Heating up
Place the pot on the cooking zone. Point the steam vent away from the body. Switch the cooking zone
on to the highest level.
Do not use a booster or power stage on induction cookers.
The rise in temperature can be followed on the Visiotherm S indicator.
During the heating, steam and a few drops of water may escape between the top and bottom
covers. This does not aect the cooking process.
The rotary knob is automatically locked. The heating up takes a few minutes (four to 20 minutes
depending on the size of the pot and the amount of food being cooked).
3. Cooking with the Secuquick softline
The sequence of a cooking process with the Secuquick softline is described below. For safe operation, all
points must be followed precisely.
The Audiotherm, which is available as an accessory, can be used to help monitor the Secuquick
softline cooking process. See the separate user manual.
3.1. Fill the pot
Fill the pot, observing the filling quantity:
 Fill with beans and other legumes to at most 1/3 full.
 Food that expands or foams during cooking – e.g. rice pudding, broths, stews, pasta casse-
roles, etc. – fill to at most 1/2.
 Fill other dishes to a maximum of 2/3.
Add liquid if necessary. A small amount of liquid (approx. 150 to 200 ml) is needed to build up the vapor
pressure. The amount depends on the size of the pot, the food and the recipe. If the food contains enough
liquid, no added liquid is necessary. Follow the recipes published by AMC for cooking with the Secuquick
softline.
3.2. Setting on and sealing the Secuquick softline
Before each use of the Secuquick softline, check that:
 The Secuquick softline is correctly assembled, and valves and seals and the cover closure are
tested.
 The sealing ring is correctly inserted. In doing so, observe alignment (top and bottom).
 The pouring rim of the pot is clean, dry and not damaged (no deformation).
 The rotary knob is in open position.
Set the Secuquick softline on the pot. Note that the position of the knob must be at the front and in the
middle between the handles.
EN
10