7. : PROPERLY SECURE MACHINE (PRODUCT) TO THE FLOOR SO THE MACHINE
(PRODUCT) CANNOT BE MOVED OR TIPPED. USE STRUCTURAL SOUND FASTENERS THAT CAN BE
PROPERLY TIGHTENED AND SECURE THE MACHINE (PRODUCT) THROUGH EACH OF THE HOLES IN
THE BASE OF THE MACHINE (PRODUCT) TO THE APPLICABLE SURFACE TO WHICH IT IS BEING
SECURED.
8. Use the four holes located in the back, bottom, or sides of the cabinet to secure the machine to a
stable structure.
9. Verify that the machine is properly secured to the stable structure.
10. Connect your AC line to the outlet. If conduit was run wire it to the power supply located in the
machine.
a. Do not use an extension cord unless allowed by the building electrical code.
b. Installation is completed. Proceed to the “Programming the Changer” section.
To Next Page
Loading...
