© 2018 American Innovations, Ltd.
Required Tools
Voltmeter
Windows
®
Laptop PC
Bullhorn
®
Tools configuration software
USB to mini-USB cable
Optional Tools
(Continued)
1 of 4
Derating Table
CAUTION: Metal relay casing on the MicroMax GPS360 will get hot. Allow 5 - 10 minutes after interruption
stops before handling the unit.
CAUTION: Do not connect the MicroMax GPS360 to primary mains power.
WARNING: Before beginning any wiring to the MicroMax GPS360, ensure that power has been turned off at
the rectifier.
GPS360 Installation & Configuration
Quick Reference Guide
CAUTION: The MicroMax GPS360 is set to use Normally Closed relays by default. If you plan to use a
Normally Open relay, check the Options > Ouput Parameters menu to ensure the interrupter is configured to
the desired relay setting (refer to Page 4).
NOTES FOR GPS360
1 On power up, the unit will stay on as long as it takes to acquire a GPS signal. Once it acquires a 3D fix, it takes approximately two minutes
to synchronize to GPS time and automatically enter the main menu or a previously loaded interruption program.
a The unit will not go to sleep while in this mode, which could potentially drain the battery. The unit must get a GPS lock to enable
power saving features. You can bypass the GPS screen by pressing PREV.
2 The unit will turn off the LCD screen (power save mode) 60 seconds after the last key press. If an interruption program was not selected
to run, the unit will enter deep sleep mode 5 minutes after the last key press.
3 While an interruption program is running, the unit will enter power save mode but continue to interrupt. You can press a key at any time
to check the status of the interruption program.
a When using start/stop or daily interruption modes, the unit will go into deep sleep during non-interruption hours. Press any key to
“wake up” the unit (see 1a).
b If you wake up a unit from power save mode during interruption, it takes two minutes for the GPS to resynchronize. The unit will
continue interrupting during resynchronization.
4 To put the unit in deep sleep mode, press and hold the PREV key until the screen flashes (approximately 10 seconds) then release the key.
Part No. 122234-000, rev0
Setup 1 — GPS360 with magnets installed; not in contact with rectier cabinet; any interruption cycle.
Setup 2 — GPS360 with magnets removed; with heatsink surface in good contact with rectier cabinet; any interruption cycle.
Ambient Temperature
Maximum Current (A)
Celsius
Fahrenheit
Setup 1 Setup 2
25
C
35
C
45
C
55 C
65
C 149 F
95
F
113
F
131 F
77
F
83
76
66
56
42 65
80
90
100
100
To Next Page
Need help?
General
