Please Read Prior to Installation:
1. Before installing any Ames assembly, Flush the Line thor-
oughly to remove all debris, chips and other foreign objects.
Failure to do so may make the assembly inoperable.
approved by ASSE (American Society of Sanitation
Engineers) to be installed in horizontal or vertical positions.
Local water authorities must approve all installation con-
figurations.
3. Allow sufficient clearance around the installed assembly
to conduct testing, servicing, and inspection. Allow a mini-
mum of 12" from the flood level to the bottom of the assembly.
4. Be sure to contact local code authorities for proper
installations.
5. If installing on fire protection system, be sure to purge air
from fire system. Fill system slowly with all inspectors test
valves open.
Attention Installer: After installation, please leave this
Instruction Sheet for occupant’s information.
Installation Instructions
Indoor Installation
Vertical Installation ASSE
2. The Ames 2000SS Backflow Preventers are
To Next Page
Loading...
