What to do if the Site Wiring Fault LED is illuminated on my Ametek Powervar ABCE1442-11R 58144-08R?
If the Ametek Powervar UPS indicates a site wiring fault, it means there's a problem with the electrical wiring at your location. The suggested solution is to contact a qualified electrician to inspect and correct the wiring.
How to fix Ametek Powervar ABCE1442-11R 58144-08R when it does not power up?
If the Ametek Powervar UPS UPM does not power up and there is no alarm, try the following: 1. Ensure you press and hold the On/Off switch for at least 3 seconds. 2. Verify the wall socket has the correct line voltage. 3. Make sure the UPM input power cord is securely plugged in. 4. Check the rear panel circuit breaker; if tripped, reduce the load and reset it.
General| Model | ABCE1442-11R 58144-08R |
|---|---|
| Category | UPS |
| Manufacturer | Ametek Powervar |
| VA Rating | 1440 VA |
| Input Voltage | 120V |
| Output Voltage | 120V |
| Frequency | 50/60 Hz |
| Battery Type | Sealed Lead Acid |
| Humidity | 0-95% non-condensing |
| Outlets | 8 NEMA 5-15R |
| Efficiency | 95% |
| Operating Temperature | 32°F to 104°F (0°C to 40°C) |
| Certifications | UL, cUL |
To Next Page
