Ametek AMP 200N - Test Equipment Details; Block Diagram and Construction

AMETEK CTS AMP 200N series
Manual for Operation V 4.0.3 22 / 60
7 Test Equipment AMP 200N
7.1 Blockdiagram
Note: Offset OUT is only supported on some models.
7.2 Construction
The main components of the AMP200N are:
- Framebus controller
- Measuring board
- Measuring U/I Adaption
- Power supply for the amplifier
- DC supply +5V , ± 15V
- Transformer
7.3 Cooling
Restriction for cooling behavior.
Rack: No restriction where to install the AMP 200N. The
rack internal cooling must be warranted.
Other: For cooling the AMP200N a minimum free space
at the rear of 20cm is requested.