Ametek AMP 200N - Technical Specifications; AMP 200 N Specifications

AMETEK CTS AMP 200N series
Manual for Operation V 4.0.3 24 / 60
8 Technical data AMP200N
8.1 Amplifier output characteristics
Frequency range
DC – 250 kHz
Signal power
250 W (nominal)
Power dissipation amplifier
250 W (maximum)
Output voltage
HIGH range: 50 V rms, max. ± 70V peak up to 100 kHz
30 V rms, max. ± 42V peak 100 kHz to 250 kHz
LOW range: 25 V rms, max. ± 35V peak up to 100 kHz
15 V rms, max. ± 21V peak 100 kHz to 250 kHz
Output current
HIGH range: Max. 2.5 A rms
LOW range: Max. 5.0 A rms
Harmonic Distortion (THD)
< 0.1%
Output Impedance
30 mΩ @1 kHz
Current protection
Short circuit protected
Overtemperature protection
integrated into amplifier
8.2 Signal generator output characteristics (built in)
Frequency range
DC, 10 – 250 kHz (sinusoidal)
Output voltage
±10 V
Dc offset
±10 V, programmable, to control external DC amplifier
8.3 Measurements (optional)
Measuring Unit AMP 200N
Frequency-selective instrument for voltage, current and magnetic field
Frequency range
10 Hz – 250 kHz
Accuracy
Better than 5%
Current measurement
External with current clamp
Range 100 mV/A: 1 mA – 30 A rms
Range 10 mV/A: 10 mA – 300 A rms
Voltage measurement
17 mV – 70 V rms
Magnetic field
Use voltage input for loop senso measuringr
8.4 General
Dimension
19", 3 HU (500mm x 449mm x 133mm)
Weight
18.3 kg
Supply voltage
115 V +10/-2%, 50/60 Hz or
230 V +10/-15%, 50/60 Hz
Input power
Max. 500 W
Inrush current (power ON)
60 A pk-pk
Fuses
2 x 6 AT (115V) 2 x 3.15 AT (230V)
Cooling
Active cooling, air ventilation
Temperature
10°C - 40°C
Humidity
20 to 85% relative humidity (RH non condensing)