Ametek Powervar Sinergy III 2kVA - Page 25

A01-00159 Rev B
25
19: Acceptable input voltage range setting
Interface
Setting
Parameter 2: Set the acceptable high
voltage point and acceptable low voltage
point for input voltage range by pressing the
Down key or Up key.
HLS: Input high voltage point
2. (Default: 300Vac)
For 100/110/115/120/127 VAC models:
140/145/150: setting the high voltage point in
parameter 2. (Default: 150Vac)
LLS: Bypass low voltage point
For 110/120/130/140/150/160: setting the
low voltage point in parameter 2. (Default:
110Vac)
For 100/110/115/120/127 VAC models:
55/60/65/70/75/80: setting the low voltage
point in parameter 2. (Default: 55Vac)
00: Exit setting
Interface
Setting
Exit the setting mode.