16308-101 Rev. A • 11
Open the box and fold the flap back along the side.
Insert the Ocu-Dot Probe box with the tray into the back of the Base
with the opening facing forward. The box will stop halfway down. Push
the plastic Ocu-Dot Probe tray all the way forward by inserting your
finger into the circular cutout at the back of the box.
Use the recess carved into the top of the base to hold an Ocu-Dot
Probe Tube.
Insert the loop of the Wrist Strap into the opening at the base
of Tono-Vera Vet.
Pull the other end of the Wrist Strap through the loop until
the Wrist Strap is secured in place.
Install Wrist Strap
It is recommended that you always use the included Wrist Strap when
using Tono-Vera Vet to prevent the device from being dropped.
1
1
1
1
1
2
2
1
2
2
3
3
Instructions for Use (continued)
Set Up Base
The Tono-Vera Vet Base features a convenient dispenser for the
Ocu-Dot Probes and also includes a recess to hold the empty
Probe Tube while taking a measurement.
Turning Tono-Vera Vet On and O
Press any button to turn Tono-Vera Vet on. The screen will display the
Reichert and Tono-Vera Vet logos. After startup, the load probe notification
will be displayed if a probe is not already loaded. Once a probe is loaded, the
measurement screen will appear.
If the batteries are low, a low battery warning will briefly appear. If the
batteries are depleted, a dead battery warning will appear and the Tono-Vera
Vet will shut off.
To turn off, press and hold the center Multifunction Button for three seconds.
Wrist Strap
Loop
Probe Tube
Holder
Pull Through
To Next Page
Loading...