Ametek Sorensen DHP Series - Table of Contents

M550004-01 i
TABLE OF CONTENTS
Chapter 1 DESCRIPTION OF EQUIPMENT .........................................................................1-1
1.1 PURPOSE AND CAPABILITIES ________________________________________ 1-1
1.2 TECHNICAL CHARACTERISTICS ______________________________________ 1-1
Chapter 2 INSTALLATION..........................................................................................................2-1
2.1 INSPECTION_______________________________________________________ 2-1
2.2 INPUT/OUTPUT CONNECTORS _______________________________________ 2-1
2.3 LOCATION AND MOUNTING __________________________________________ 2-1
2.4 WIRE SIZING ______________________________________________________ 2-4
2.5 OUTLINE DRAWINGS _______________________________________________ 2-4
Chapter 3 OPERATING INSTRUCTIONS..............................................................................3-1
3.1 CONTROLS AND INDICATORS________________________________________ 3-1
3.2 BASIC OPERATION _________________________________________________ 3-2
3.3 LOCAL OPERATION_________________________________________________ 3-8
3.4 REMOTE CURRENT PROGRAMMING __________________________________ 3-8
3.5 REMOTE VOLTAGE PROGRAMMING __________________________________ 3-9
3.6 REMOTE SENSING _________________________________________________ 3-9
3.7 REMOTE OUTPUT ON/OFF CONTROL ________________________________ 3-10
3.8 REMOTE OVERVOLTAGE SET_______________________________________ 3-10
Chapter 4 AUTO-STEP PROGRAMMING.............................................................................4-1
4.1 INTRODUCTION____________________________________________________ 4-1
4.2 PROGRAMMING____________________________________________________ 4-1
4.3 RUNNING A PROGRAM______________________________________________ 4-4
Chapter 5 CALIBRATION..........................................................................................................5-1
5.1 INTRODUCTION____________________________________________________ 5-1
5.2 REQUIRED EQUIPMENT _____________________________________________ 5-1
5.3 CALIBRATION PROCEDURE__________________________________________ 5-1
Chapter 6 MAINTENANCE.......................................................................................................6-1
6.1 INTRODUCTION____________________________________________________ 6-1
6.2 PREVENTIVE MAINTENANCE_________________________________________ 6-1