Communications Options
M370430-01 Rev B 6-19
Figure 6-22 New Connection Dialog Box
5. In the Connect using: box, select “TCP/IP (Winsock)”.
6. In the Host address box, enter the IP address, obtained in step
14 of the section entitled “Assigning an IP Address to the
Power Supply Unit” on page 6-12.
7. In the Port number box, enter “10001” as the value.
8. Click OK.
To specify the terminal connection properties:
1. Click Disconnect if necessary, and click Properties in the
main HyperTerminal window. See Figure 6-23.
To Next Page
Loading...
