13
English
Run program
Step through program
Verify program
Run program
continuously
Stop program
Save as
Pause program
Run program from step
Record program Tortoise mode
Program properties
Run program ‘n’ times
1. New - To start a new program, click the ‘New’ icon. A blank program tab
will appear each time the ‘New’ icon is selected.
2. Open - To load an existing program, click the ‘Open’ icon. Browse to the
correct ‘.thprog’ file (default Metrology 4.0 file type).
3. Edit - If a user has access, ‘edit mode’ can be selected and changes to
the current program can be made. Click the ‘Edit’ icon (If icon cannot be
seen, then the administrator should change the user’s role to give editing
access). Once in ‘Edit mode’, there are options to delete, cut, copy and
paste program steps along with undo and redo functionality. Program
steps can be expanded to view more information. Click the ‘arrow’, or
alternatively the ‘expand all’ icon.
4. Lock - Click the ‘Lock’ icon to close ‘Edit mode’ and stop any further
editing to the program.
5. Text edit - When in ‘edit mode’, there is the option to edit the text
file associated to the program. Click the ‘Text editor’ icon, to open the
‘.thprog. file in a text editor.
To Next Page
Loading...
