Ametek Universal III 509-7X Series - Page 19

96 pages

To Next Page

To Previous Page

Installation

Figure 2-8

Universal III Wiring Connections

Remote Mounting

2.3 Wiring the Electronic Unit (Continued)

Main Page

Table of Contents7
Section 1: Introduction9
System Description9
Technology9
Model Numbering10
Sensing Element Reference Number11
Area Classifications12
Section 2: Installation13
Unpacking13
Mounting the Electronic Unit16
Wiring the Electronic Unit18
Wiring the Sensing Element20
Spark (Static Electricity) Protection21
Surge Voltage (Lightning) Protection23
RFI (Radio Frequency Interference) Filters24
Electrostatic Filters26
Digital Integral Meter27
Section 3: Configuration & Calibration with Drexelbrook PC Software30
General Description30
Model Number30
System Requirements30
Installing the RS232 Modem31
Install the Windows Version Hartwin Software on Hard Drive33
Description of Function Keys33
Configuration35
Calibration37
PC Status Messages41
Set D/A Trim42
Strapping Table42
Digital Integral Meter Configuration44
Save/Print Entries44
Validation45
Calibration & Configuration Via 401-44-3 Display/Keypad48
Drexelbrook Device Description50
Start-Up50
Configuration51
Calibration53
Section 5: Configuration and Calibration Using the Rosemount™ Model 275 Communicator Without a Drexelbrook Device Description58
Range / Span Control58
Rules & Conventions of HART Configuration Software (Model 275)59
Tag ID59
Set up Procedures60
Reading Input and Output63
Calibration Using Actual Tank Level64
Bench Calibration (if Needed)65
Point Calibration67
Handheld Calibrator Error Messages68
Section 6: Troubleshooting70
Identifying a Problem/Symptom71
Troubleshooting Loop Connection71
Rosemount Mod. 268 or 275 Calibrator Cannot Identify or Find Device72
Rosemount Mod. 275 with Device Description Cannot Identify or Find Device72
Transmitter Does Not Communicate with Drexelbrook PC Software73
Troubleshooting Transmitter74
Troubleshooting Sensing Element76
Troubleshooting Coaxial Cable77
Static Electricity79
Radio Frequency Interference79
Factory Assistance79
Field Service80
Customer Training80
Return Equipment81
Universal III Troubleshooting Guide82
Section 7: Specifications84
Transmitter Specifications84
Coaxial Cable Specifications85
Section 8: Normal Maintenance86
Viewport Cleaning86
Section 9: Drawings88
Fm / Csa Approval Drawings88
Kema Approval Drawings92

Ametek Universal III 509-7X Series - Page 19

Table of Contents